Recent content by 252Imports

Ground the edges yesterday and keyed in some areas at doors and stuff. Thoroughly vacuumed the slab and then pressure washed. The angle grinder created an unbelievable amount of dust but I feel I did a top notch prep job. One thing I did learn is that i will never tackle a dusty job without a...

Also, this is a pic of the transition under the bay doors going outside. The unground concrete is outside. The step is about 1". Can't decide whether to grind a groove just back from the edge to stop at, let the epoxy run over the edge, or try and mask or put a 2x4 against the edge to come to...

I really just met Fred through dealing with him on the floor and am not sure what he has been dealing with. He has been more than helpful though and I hope I haven't been too much of a bother during whatever he is recovering from. Here are some pics of before and after the grind as well...

Hello all. After doing quite a bit of reading on the forum about different flooring options and getting some great info from Fred @ Alpha garage I decided to epoxy my 1500 sq ft shop space. I figured i would contribute the documentation of my project because I've learned so much from reading...