Recent content by 3335173

I had the exact issue with my last garage. I wanted that factory edge on the entrance but needed them to meet in the rest, so it will have to be one whole tile off. The My solution was to adjust the layout so one door, the tile edge was about 4" inside the garage door and the other was about 2"...

I have FreeFlow, XLC and 3x3 smoked oak large format all connected. The XLC to FreeFlow there is virtually no height difference. There is a significant "lip" where either meets the smoked oak. I thought there would be a catch/trip issue, but it has not been a problem, though in the traffic area...

I just finished a 36x26 detached garage in Phoenix AZ and installed a 24k BTU Cooper/Hunter 2-zone mini split. The building is wood frame 2x4 construction, 9ft ceiling, with a south facing 16ft door, a 72" sliding door and 8, 10"x40" transom windows on the east and north side. I used open cell...