Recent content by 46oneton

Live in Oklahoma, so humidity is high temperatures aren’t so bad does get hot have a water separator right after the pre-cooler before the air enters the tank

Live in Oklahoma, so humidity is high temperatures aren’t so bad does get hot

I live in Oklahoma so it doesn’t freeze very much. The heat is the problem. Don’t really plan on heating or cooling the cabinet. My shop has mini split in. It may open up the wall to vent some of the air from the shop into there. That’s probably a good idea. Thanks.

Already have 80 gallon. Ingersoll ran the whole set up only cost me with pre-cooler and air dryer about 800 bucks.

A per cooler is where the air comes out of the compressor motor through a transmission cooler, then through a water separator, and then into the tank the transmission cooler cools the air enough to separate it from the water

I have a water separator after the pre-cooler before it goes back in the tank

I have a water separator right after the pre-cooler

that's what I was wondering should I put the per-cooled in side then to my water sep. out side and then to tank ?

I am putting my compressor outside of my shop in a closet. I will have a pre cooler on it and once it gets in the shop I have a HF air dryer on it has anyone done this any comment's? I do all types of work on cars frame restomods frame off body and paint

I am also looking for floor ideas I need one to stand up to welding I heard epoxy will show burn spots any thoughs