Recent content by 4ruinner

Well, I bought an OTC bearing splitter (1130) about two years ago. It says "Made in the USA with globally sourced components" Whatever that means. I also have a bearing/pulley puller (4534), this one is made in Taiwan, bought it around the same time. So far they've done their job.

My transformer style 211 is sitting on one of those carts right now. It fits, however, I had to put a piece of plywood under the welder to raise it up a little bit so I can open the door. It's not the best but it's done the job so far, I don't move it around much. I did make a bracket for the...

I was under the impression that a cylinder that has a company name stamped on it belonged to the company not the individual. I thought bought bottles should not have any company's name on them. I bought a bottle from a welding supply a few months ago and it does not have any company's name on...

Usually happens at junkyards where someone wants to borrow a socket or screwdriver. I once let somebody use a deep 12mm socket, after a while I had to look for him all over the place just to get my socket back. After that, it is a "no" or "I don't have one" I don't need to be chasing anyone...

I bought a DeWalt 18v xrp set about 7 years ago, I'd say I've abused the drill a little too much and hasn't let down yet. That being said, I tend to consider where the products I buy are made. (Some) DeWalts are at least assembled here in the States while the others are not, at least not that I...