Recent content by 65Val

Ok. Thanks for your efforts!👍

Again, I can’t see my FIL changing out the springs if he didnt have to…and there is air getting into the gauge section… I have checked that.

I have the unit hooked to my 3/4 ton pickup with 65 lbs in the tires, so I think should read something, even if not correct.

If I hook it up to a tire valve and supply air, with no gauge assembly installed, air from the tire comes out the gauge area, so air is getting to the gauge assembly area. I have seen the gauge function properly in the past, and I don’t think my Father-in-Law would replace the spring if it was...

No air flows in that configuration.

You mean completely disassembled?…just supply air hooked up??

“(Does air flow if you just plug the quick connect into a pressurized line. If not, confirms a valve)” No. Air flows only flows when red button pushed.

There are no numbers anywhere on the unit.

There is no air leaking from anywhere when the supply air is hooked up to the quick disconnect, and the chuck is on the tire valve.

Have not messed with the springs…they do seem very “heavy”…takes pliers on the end of the slider to pull it out.

No.

Yes.

It’s not sticky… I’ve cleaned it thoroughly.

I have done that… all clear. I’ve run tiny wire through all the passages.

Exactly as I remember. My problem is the slider/gauge isn’t moving to show the tires’ pressure. It will air-up a tire just fine.