Recent content by 66ragtop

Finally got around to working on the heater. I set the pressure to 3.5 lbs and it works perfectly. Thanks for the help

I have the exact same issue. I posted just the other day. It was recomended to clean the rotor and blades in the air pump. I tried it but it didnt work on mine. I think i might try to increase the air pressure at the pump.

Cleaned and set the gap per the manual, still no good. Should i try adjusting the pressure Thanks Brian

Thanks, I'll check it out tomorrow and let you know

I have a Reddy Heater 60,000 kerosene torpedo heater. It fires up and runs for about 10 seconds. I took the top off and ran it to see what might be going wrong. Oddly it wouldn't quit. So I put the top back on and it went back to only running a few seconds. If I take the top off it and start it...

Which densifier should I use?

The builder will be pouring the floor in my new shop in the next few days. I have decided to keep the plain concrete floor look but will be using a densifier to make spills easier to clean up and keep the dust down. My question is when do I apply the densifier? Thanks Brian