Recent content by 68SS2

  1. 6

    The “Green Beast” 1940’s Equipto Cabinet Restoration!!!

    Sorry, my single drawers are not that size. Good luck finding a match. -Doug
  2. 6

    The “Green Beast” 1940’s Equipto Cabinet Restoration!!!

    I just purchased a whole stack of bins like those. I will look tonight if I have one that will match your set. Where are you located? I hate to see a set get that much attention and not be complete. -Doug
  3. 6

    My shop equipment restoration and fabrication

    Bryan, Your detailed work on the equipment restoration really looks nice. By reading this thread I have picked up some of your techniques for restores various parts. For the rest of us that don't normally work on rebuilding this type of equipment maybe you could just give us a run down on the...
  4. 6

    Autoquip Scissor Lift Table

    Series 35 2500lb Scissor Lift Table. Lift table is in excellent condition and used very little. Includes handheld controller. Under table scissor lift mechanism looks new. Also includes safety curtain/bellows. Unit is 3 phase powered, but a replacement motor can be bought from Autoquip for...
  5. 6

    Mr. Heater Big Maxx Problem

    I want to buy a Sterling 45k heater that is very similar to the Big Maxx or Big Dawg. On the Sterling you can pull fresh air from outside to burn then vent back outside the garage. The Modine and Sterling cost about the same. Does anyone have any hard feeling about either one of these, except...
  6. 6

    Parts Cabinet Stand

    What did you do to prep the cabinet surface and what kind of primer did you use? I am getting ready to paint some Vidmar cabinets that I believe are powdercoated. I was planning to rough them up with 400 sandpaper and start with primer. What is your plan with your vidmar? Thanks
Top Bottom