Recent content by 70 140

Great so far. Cooks Bay?

The T&G looks really good.

Oh Well

Where are you in NWO?

I really like that crew cab F-series hauler. Was the deck cover a custom add on?

I think you're making it too complex by trying to design a moving platform attached to the lift. I would design it to hinge on the floor - probably along the long side against your wood framed wall. This puts the weight of the platform on your floor, not the lift. Use the lift to open and close...

Did someone previously keep pigs or something in the building? The floor looks like it was set up for a stable cleaner.

Anchor the mast of a reclaimed forklift to the wall - with the basement slab floor bearing the weight. Run the hydraulics off of an electric pump - like the type used for those portable mid rise lifts. Build a removable platform to slide on and off the pallet forks. When not in use, close off...

I fooled around with it a little today. Decided to leave it at 220 and run it off the generator until the wiring gets re-done.

Thanks for the info. Its an older T30. I believe the motor is a 3hp, but I can double check that. I will be running this off of a dedicated 20amp circuit until I get the re-wiring done.

First time poster, been lurking a while though - mostly in the gallery. I bought a used IR T-30 compressor that has a 110/220 single phase motor on it. It is currently wired for 220. Long story short, I have 220 service in the garage, but need to do some serious re-wiring (mostly de-wiring all...