Recent content by 8587GN

my garage is split into 2 sections, one is 30x50, with a 9x8 garage door. the other section is 30x30, with a 9x8,and a 16x8 garage door. Now I have hanging Reznor heaters in each section. the bigger shop has a sealed combustion heater[I had my cabinet shop on that side, so I could spray paint...

I should note that I had builder grade insulated doors before i i

I just wanted to give my 2 cents on the insulated Haas garage doors I had installed last fall. Over this past winter I used one less 250 gal tank of propane. My garage is split into two sections. One section is 1500 sq ft, with 1- 9x8 door[ kept at 63 all of the time. the other section is 900 sq...

thanks for the info

I just had this opener installed 2 weeks ago. Where do I get the parts, or hardware to hook it up so I can use it with my phone ?

Here we go again on how everyone thinks that the Amish are the best carpenters.......WRONG !!!!!!!!!!! I`m a finish carpenter and had to trim new houses that the Amish framed. Nothing was plump,square or even 16" on center,they are the worst around. The builders use them because they are cheap I...

my ceiling is 10'-6"

We assembled my PP 8 yesterday afternoon in about 4-5 hours. We had three guys, but called my neighbor for a fourth to help get the ramps off the trailer. It went together without any issues, and I rolled it into my car side of my shop today.

I just bought the PP8. Myself and 2 friends will be putting it together this Sat. I,and another friend bought two of them this past weekend, he put his together in about 4 hours, and will be helping this weekend . I cant wait for some garage floor space back

he bought it new in 1999

Is $2500 to much for this ? Or for a few hundred more, get a new Bendpac ?

I really like it. I use it alot more than the RO125, I find its easier to handle than the RO125

I had the same thought, until I used the track saw. Theres no comparison to any circular saw out there. I bought one about two months ago,and I find myself using it more and more. Since a year a go, I bought the CT 26 vac, the RO125, and ETS125[sanders] the T55 saw, and the 1400 router. The...

I found a used Eagle 4 post lift for sale about a mile from my house. They want $2500 for it. I think its a bit to much $$$$ for a used lift. Its supposed to be US made, all the info I can find on it is its model number is 886000. heres a few pics of it. Thanks for any help on this

why not find a local lumber yard and get finger jointed poplar ? it normally comes pre primed as well