Recent content by 85YotaMan

Nice garage/tools! Great lookin tube work/fabbin skills! Looks like you've got a very good selection of dies for yer bender... :beer: And like you mentioned in the beginning of this thread, having a hydro bender vs manual - (roll bender around vs single point of bending) I recently made the...

Here we go! Excited to see this beast come together :D

WOW... so where's the other shop that's full of all your stuff/junk/clutter/****!?!? AMAZING man good work and excited to see the cart finished! :beer:

We ALWAYS do expansion joints, it tells the concrete where to crack so you don't have a ugly diagonal crack going across your nice slab... We run a 1.5" deep jointer tool across the slab which separates the rocks, then 20ish minutes later we go back across the joint with trowels to fill it in...

:beer: Good stuff Curt! I joined this forum after you mentioned it to me and FINALLY got around to reading your build thread! Looks really nice! And the Miller 211 is what I run now, great little welder that can keep up with the big boys but also portable! Wish my shop what this clean...

I also weld rebar often, for concrete application and art work... There is nothing wrong with welding up the joints in the rebar for a table. Supposedly it weakens it if not the correct grade... riiight. Once the concrete is cast into place it's not going anywhere, tie wire works good too. How...

With the BOX, Grandpa approved! :thumbup: