Recent content by 997Turbo

That link is great! Thank you so much.

Reattempted. Drew it, basically, in paint.

Does this work? https://www.dropbox.com/preview/Keswick%20House/Screen%20Shot%202020-04-22%20at%203.12.51%20PM.png?role=work

Could I get your advice on my garage below? Happy to Venmo or PayPal you for your service! Value and respect your time and skills.

6" inches >4000 PSI

My other thought was: HD-9SW Then put a Bendpak SP-7XL scissor lift under it for servicing lift.

Sir, thank you for your comments. Attached is garage layout. I'm trying to see if I can position to lifts side by side (one four post and one 2 post) so that I could drive two cars in to their respective bays between the lift posts acknowledging veering off a bit. Bendpak are the lifts and I...

Happy to pay someone for the following: 1. Draw my garage floor dimensions in a computer program of some sort 2. put various lift sketches (based on MFR drawings) in there so I can move them around to figure out lift setups Willing to pay for the task!