Recent content by _Stang_

My 10x16 shed sits on a slope almost identical to what Jeff95TA shows above. I did a 6x6 timber perimeter, about 3-1/2 ft high in the rear with crushed limestone fill compacted every foot. You could park a large vehicle on there without issue although the heaviest thing I have is a ~1000lb...

They're superior to any lag bolt I've ever used. The structural screw is a much smaller diameter yet with better holding capacity and it drives like butter. Nothing better for hanging shelves, TV mounts, etc. I just used some this weekend for a 1x4 header board to mount a barn door track on...

Had the Amish do our 12x16 Pavillion. They had the roof somewhat done in their shop beforehand (beautiful tongue & groove ceiling) but there was a lot of work on site to be done. They showed up with two men and two 12 year old boys around 10 am and were DONE before 2pm. I made a comment that I...

Seafoam per the directions on the bottle anytime I fill up my gas cans. Run my equipment as usual and never drain or even run dry. I'll throw a little extra seafoam in the tank of the mowers last few cuts of the year or snow blower near spring. Never had an issue starting or running anything...

That looks RIDICULOUSLY good Sent from my SM-G950U using Tapatalk

Here are a few tips on cleaning that I can offer. A good stick vac like a Dyson animal cordless which has great suction will pull up lot of dust / dirt lurking below the free flow tiles. Shop vac is too cumbersome for me to drag out, set up, pull around and then put away although it works just...

Fuel consumption is based on load. Sent from my SM-G950U using Tapatalk

Why are you worried about 3% VD with low voltage led landscape lights. Sent from my SM-G950U using Tapatalk

Electrician who wired the house and remembered how he ran everything, inside access to the eave in a storage cubby hole and a wee bit of luck. Sent from my SM-G950U using Tapatalk

Square D AFCI in all living areas in our 4 year old new construction home. Had exactly one recurring nuisance trip in those 4 years which turned out to be a wire ever so slightly nicked by an exterior trim nail along an eave. Sent from my SM-G950U using Tapatalk

Say what? These are breakers manufactured by Eaton Electrical to fit a variety of panels and they are classified as such with UL. The brochure even says in large type, "UL Classified to fit virtually any panel, even Square D Homeline" Sent from my SM-G950U using Tapatalk

There is, Eaton UL Classified line mentioned above. https://www.eaton.com/content/dam/eaton/products/low-voltage-power-distribution-controls-systems/circuit-breakers/classified-circuit-breakers/ul-classified-replacement-circuit-breakers-sa00304001e.pdf Sent from my SM-G950U using Tapatalk

Eaton makes a UL Classified breaker line for use in SqD Homeline, GE and others but believe the 2pole only goes up to 50A. CL250 Sent from my SM-G950U using Tapatalk

NewAge Pro 3.0 I'm partial to the platinum / white Sent from my SM-G950U using Tapatalk

Love the shakes. Definitely a process. I've seen Tom Silva do it a few times on TOH and he makes it look easy. Love to watch that guy work. Sent from my SM-G950U using Tapatalk