Recent content by Aauman88

  1. A

    Newbie with new shop!

    Thanks for the replies. Over both roll up doors there is a six inch gap when doors are down. Has to have room for coil to get bigger as it rolls up. The wall posts are 2 1/2" and is stripped with 2x's with the insulation trimmed only where plywood went up. So it is roughly 4" thick on bottom 8'...
  2. A

    Newbie with new shop!

    Ok still dealing with my moisture problem and looking for a few recommendations. Have removed all mdf from shop due to the mold growth and just found the mold on 60% of the surfaces inside the mustang I keep stored in shop!! Removed car and worked in shop most of day yesterday with doors open...
  3. A

    workbenches...

    Well I was all set to buy a 42" upright tool chest (5-6' tall) and it was priced around 1100. I went to buy it and found it had no drawer liners! Another 100-150! Got mad and left and found these. Now I have five times the space I would have had and have the same money in it. Very solid products...
  4. A

    WTB insulated socket set. SAE. Other insulated tools

    Need a good set of double insulated socket set. Full or partial. Also insulated hex key L wrenches. Let me know of any insulated or composite electrical tools you want to get rid of
  5. A

    workbenches...

    Only had them a month and shop for two months so don't laugh at the bare shelves. Absolutely thrilled with the line of products. Best deal out there!
  6. A

    Automatic foundation vent

    Anyone used these automatic foundation vents. Open at 70* and closes at 40* by there self with no electricity. Thought about using on backside of my shop in the wall to help ventilate shop. Back of them would be accessible from inside if I wanted to force closed or shut. They will fit between...
  7. A

    Newbie with new shop!

    I see no other signs of high humidity but I have not checked the dew point. Did I not wait long enough for slab to dry/cure? Will ventilating it help or will I have to run dehumidifier?
  8. A

    Newbie with new shop!

    Middle Georgia. Concrete was done two months before building put in. Another month before insulation sprayed
  9. A

    Newbie with new shop!

    Ok I just got my shop installed two months ago. It's Carolina carport 24x40x9 with vertical roof. I had the entire interior spray foam insulated and then went around the walls with 3/4 osb tongue and groove stood up. It's on concrete slab that does have moisture barrier. Two roll up doors, one...
Top Bottom