Recent content by Aclarke2000

  1. A

    Replacing Craftsman 113.xxxxxx arbor bearings.

    Did you ever figure it out? I found a wavy washer, looks like it should sit in the bell next to bearing. I thought it was damaged/ bent.
  2. A

    Air compressor pump discharge materials? Class 300 iron, L copper or other?

    Thanks for the suggestions! Looking forward to completing my first large compressor.
  3. A

    Air compressor pump discharge materials? Class 300 iron, L copper or other?

    Got a used tank and need to mount the new motor it came with. Also need to build an exhaust to go to the tank. I've read that copper soldering is not recommended. I see class 300 iron (150 psi at 300F) should support the heat, but very pricey. Any suggestions on best material to use? Setup...
See more
Top Bottom