Recent content by Agotham

I used absolute steel great to deal with did everything myself except concrete all the plans are included stamped by engineer for your state

Was under the impression the air gap was needed with rigid foam my sides are 4" deep so 1 1/2 on wall and 1 1/2 flush leaves gap but if there is no benefit I'll do dual 2"

It is on concrete and attached to it base rails are sealed at concrete

Going to be a bit of waste cutting it at 4*5 so 3' of waste per might be able to use some of that on second layer though just trying to find an option that will not cost a fortune yet have a good end result

Almost finished with my steel building 34*30 10.5 ceiling 6k concrete 10.5 k kit 500 permits 1 k in electrical and lightning 1 k garage doors and openers figuring 2 k insulation and electric heat all labor done by me

They recommend spray foam but foam board is option first layer cut to fit tight and seams taped will then frame a little for future cabinet placement and install second layer flush with studs and thinking osb interior walls diamond plate on bottom 4' over that

First off want to say hello new member been looking at site for a while but this is first post. First my shop is largest I could build in the city limits 34*30 with 10.5 ceiling. Finally am ready to insulate it and thinking of using rigid foam double 1 1/2 on sides and roof with 1" airspace and...