Recent content by AIRCAT Tools

  1. A

    3/4 impact wrench... Whos got one?

    :beer:
  2. A

    good 1/2 impact for under 200?

    I think you would be surprised at the quality of the AIRCAT products. Nothing comes from China and the internal parts are made will the highest grade steel, plus the bearings come from Japan/Germany and several internal parts are USA made. Assembled in USA High quality all-around products.
  3. A

    The Truck Tool Equivalents Thread - Gathering Data

    Mac Mac Tools 1/2" Impact Wrench (AW612Q) - Aircat 1/2" Impact Wrench (ACA1100K) Actually it is the Nitrocat 1200-K (ACA1200K) AIRCAT also builds the MAC 3/8" 3/4" and "mini" 1/2" Impact Wrench models.
  4. A

    twin clutch? or twin hammer?

    Think of it like a bell curve, the tool is rated to hit anywhere from 200-900 (ft-lbs) depending on Flow Pressure. It's an accumulative rating. Actually at less than 90PSI (60 PSI or so) you would be down at the 200 level...
  5. A

    twin clutch? or twin hammer?

    The Max Torque - which is no longer printed was rated at 120 PSI, now you will see working torque with gives a range of torque, depending on PSI, also the key to getting the highest torque output is based on Flow pressure, if you compressor is at 120 PSI, but if you run a 30 foot hose, the flow...
  6. A

    twin clutch? or twin hammer?

    I have attached the images of both mechanism's. Twin Clutch (Pin-Clutch) - Hard initial hit, more torque, smooth, low vibration, slower RPM/BPM Twin Hammer - Sustainable Hit, Higher Vibration, Faster RPM/BPM
  7. A

    1/2" guns: MAC AW612Q (aircat) and Chicago Pneumatic 7749

    Peter, The MAC AW612Q is equivilant to the NitroCat 1200-K 1/2" Twin Clutch Impact.
See more
Top Bottom