Recent content by akkahuna

I can't see close enough but you have spring nuts threaded to the allthread inside the channel and square plates and nuts and lock washers outside the channel? So you have a redundant lock on it? Looks good to me, my 100K heater comes with 3/8 threaded mounts installed on the heater so I do Not...

I have just never used before but this is what was recommended. I have installed the "Superstrut" channel with allthread through the trusses, it is going nowhere. I have the allthread attached to the heater and when I get some help I will mount it with the spring nuts to the ceiling. ??? The...

It will have to be 3/4 inch pipe or you will not get the gas flow needed for a 75K heater over that distance. I had to run 1" pipe to cover 130 feet supplying a 100k heater, as per the local gas company and an engineering friend of mine.

I have a modine hot dawg 100k heater. My shop is 40x40 with 14 foot ceilings. I plan on hanging the modine down from the ceiling about 5-6 ft on allthread 3/8". This way it is closer to the floor for drying stuff and warming when it -40 outside in the winter. I have never used the superstrut...