Recent content by AKMac

Well, this panel will be feeding a 60x60 shop, with a mill, lathe, drill press, several welders, several bandsaws, etc. It will also have a full mother-in-law apartment with a full kitchen, washer dryer, water heater, A/C, etc. I figured 200amps would be safe.

Before I begin, let me state that I have done my best to search for an answer. Also, I have very limited electrical knowledge :shocking: I currently have 200amp service. I am out of breaker spots on my main breaker panel, so I'm going to hire an electrician to replace this...

Should be around 130 lumens per sq ft. My biggest concern is the 5ft gap between the wall and the fixture.

no one?

Hi guys, I'm just wondering if I can get some insight into my lighting layout. I'm trying to light up a 6 car attached garage. Each bay is about 23ft wide, with the deep bay being a little over 40 ft wide. The ceiling is about 10ft. The walls and ceiling are painted glossy white. Currently I...

Haha, maybe I am a wuss and I'm blaming the shovel! ;) Although, last fall I was shoveling a flat bed trailer full of dirt and thought how much better my back would feel if I wasn't bent over at a 30 degree angle the whole time! I've looked at Lowes and Home Depot for shovels and can only find...

I'm just curious if anyone on the taller side has found a digging shovel (or square mouth) that fit's taller guys? I'm 6'4" and most shovels give me a lower back ache after a while. If I could just get a shovel with perhaps a 68"-72" over all length, I would be much more comfortable. I've...

Very nice! I too would be interested in the truss specs :)