Recent content by AnEv942

I converted a $10 harbor freight grinder (brushed) using Klutch stand to use as mini chop saw. I also it converted to use 6" cut off wheel so need to slow it down. I used a simple rheostat (old light dimmer) that I had to slow down & control/ vary speed. Works well. Grinder is hardwired to...

Came across this on other forum, OD numbers different but... https://www.lumberjocks.com/topics/28357 Id lean toward heavier wall pipe/tube, cut column above chuckl height, insert something close to ID in both halves. Drill&tap thru both bolting as shown above. Unless bolted down may need to...

Mine, an 8" Oldforge 73A brake adjuster... Given to me late 80's. Has to be one of my most abused and used tools.

Depends, mine older T-583 16spd. uses 1/2" belts (stock# was 'v-belt' according to the manuals part list :) ) But came with; A27-29" outside dia A28-30" outside dia Though I changed to an A27 with a A29 (31") on motor pulley to shift center pulley as I have counter weight, plus the stock...

Exactly-knob assy. does not use the hole, its only clearance to insert. If it covers-your done.

As far as moving hole I'd probably use rasp or drum sander instead of trying to redrill as I'd make a bigger mess. Pictures look like hole is not as far off as latch sticking out. Like, depending on knob style, it might cover? That' be too easy. Scar plates simple enough. On the latch, I...

Looking for units 4 sale would yeild manual Dua Fast 5000 series staples- just one source-https://www.stapleheadquarters.com/DuoFast_50 parts breakdown https://www.repairtoolparts.com/duo-fast-parts/duo-fast-ct-859-a-parts-list

Why?

Ya hard to see but I'm curious...

If you had access most I would do is raise the tee in wall if siphoning was an issue. But I cannot see how placement could possibly cause water in trap siphoning out. All I see being accomplished by lowering the P-trap down is decreasing area under sink for items stored. I did virtually the...

Only curious why not just use not quite as deep as it should be bolt? Add addtional if needed

Many reasons to block, spreads loads between joists, keeps joists from rolling, overall stiffer platform, supports the decking where spanning- but in th OPs case simply wouldnt be needing to go back trying to seal out critters.

Blocking between joists, at minimum, should have been added where plywood butts.

Type to slow Ya manual embossing Dymos are still available, https://www.walmart.com/ip/Office-Mate-II-Tapewriter/21067150 They also make a smaller one. I have at least 3, one being nice old chrome #1550 unit, several different embossing wheels. Tape is getting harder to come by. Still find the...

Dont know abd? I get ~9 13/16" from work bench to top of case Thats standing on its rubber feet ~5/8" Tallest though is the regulator-depending how its installed for height Handle standing is 2 13/16" above top, laying flat is 1 1/16"