Recent content by arch stanton

  1. A

    WTS Milwaukee Hydraulic Floor Jack model 40 4 ton. SOLD

    bump
  2. A

    WTS Snap On QJR284D Torque Wrench 3/8 appears new old stock SOLD

    WTS Snap On QJR284D Torque Wrench 3/8 appears new old stock SOLD email with inquires
  3. A

    WTS Milwaukee Hydraulic Floor Jack model 40 4 ton. SOLD

    WTS Milwaukee Hydraulic Floor Jack model 40 4 ton. Very nice holds the load no leaks or defects. Would prefer local pickup in Wisconsin If shipping is desired the buyer would have to send a call tag and pay shipping. If you need it crated the cost would be on the buyer as well. SOLD plus any...
  4. A

    Turning Reelcraft air hoser reel into pressure washer hose reel swivel question

    That's my conclusion. I am going to tap the existing fitting and install a 3/8 swivel and take off from there
  5. A

    Turning Reelcraft air hoser reel into pressure washer hose reel swivel question

    its 1/8" thick Thanks
  6. A

    Turning Reelcraft air hoser reel into pressure washer hose reel swivel question

    its the same as the reel craft pressure washer reels they make already but I can't use that swivel its a different thread pitch
  7. A

    Turning Reelcraft air hoser reel into pressure washer hose reel swivel question

    I see what you are saying but I believe it will handle the higher pressure its a piece of heavy wall pipe that runs through the reel
  8. A

    Turning Reelcraft air hoser reel into pressure washer hose reel swivel question

    because that is what the thread is on the reel already so I need to adapt from that its an internal thread
  9. A

    Turning Reelcraft air hoser reel into pressure washer hose reel swivel question

    This is why I want to change the swivel that came with it so it will take the pressure
  10. A

    Turning Reelcraft air hoser reel into pressure washer hose reel swivel question

    I am turning a Reelcraft air hose reel into pressure washer hose reel. The question is where can I obtain a swivel that has a thread pitch of 3/4-16 munf? Cant use the existing swivel it would burst under pressure. There doesn't seem to be much out there for a fix maybe an adapter of some sort...
  11. A

    Anyone come up with a way to use Starlock on Dewalt oscillators

    Since this thread I did buy the Dewalt and it comes with an adapter you can use for other blades that dont fit the setup. Basically a dimpled washer and screw attachment. Not a big deal to changeout the blades this way. Now I can use the left over star locks
  12. A

    Anyone come up with a way to use Starlock on Dewalt oscillators

    I have many starlock from the Fein that I just have worn out
  13. A

    Anyone come up with a way to use Starlock on Dewalt oscillators

    Anyone come up with a way to use Starlock on Dewalt oscillators? I would like to buy a cordless Dewalt Atomic oscillator but it appears they dont use starlock accessories. Thanks Joe
  14. A

    Show off your Jack(s)

    Latest Jack Milwaukee model 40 doesn't leak holds a load. All I did was paint it. $50 is what I paid Does anyone have good picture of the sticker on the side I can replicate? Milwaukee Hydraulics is unresponsive to communication. Also if you have a Milwaukee is the bar stud for the level stud...
  15. A

    Need picture of Walker 882 series C jack name plate

    Still looking for a good picture of the above name plate does anyone have a picture they could share Thanks Joe
See more
Top Bottom