Recent content by AshurB

That makes sense. It shouldn't been to hard to cover the gaps. I'm not to worried about the r value. My main concern was stopping the air coming in from the soffit. With these vent I caused a small draft but I haven't put any baffles or blockers to stop the air from coming in and I'll put the...

I ended up putting up the rafter vent to the ridge. I was told I needed spacers but due to the wood blockers I didnt put in spacers in some. Is there a benefit for the 1" spacer?

I've bought the foam insulation vents. They are 22". My rafters are 16"oc I dont see how I'm supposed to cut them to fit inside and still have it vented. If I cut along the perforation they are only 11".

Ok sounds good. Thank you.

Would this be what I would need? I would just line it all the way up www.amazon.com/AccuVent-Flame-Retardant-Attic-ACBP11754/dp/B01G2HVBVG/ref=sr_1_3?ie=UTF8&qid=15441559

I knew this wasn't a normal situation. I'll put baffles in every cavity to start then work on the ones without blockers. Save the blocked cavities for last.

That was my fear. Yes, I will be putting insulation right under the roof.

Ok the rafters are made of 2x6s if I were to use faced batts or rolls for 2x4s that should leave plenty of room above the insulation to get past the blockers

I will be putting in fiberglass insulation. Do I put baffles from the soffit to the ridge in every rafter?

I am in the middle of insulatating my attached garage. I have finished the walls and waiting on a kit for the door. Now to the ceiling, there is a soffit on the front and back of garage with a roof ridge vent. I would like to insulate the ceiling but due to blockers in the rafters I can't seem...