atch's latest activity

From Ryan's original post: 3. Vintage Craftsman Drill Press. Tools from the 1940s make me genuinely happy in a way that is difficult to...

4x4's

This doesn't have anything to do with anything. Just me not being able to keep my mouth shut. I have a friend who showhorned one of...

Turned an unused tray into a tool creeper.

Killing time while I'm waiting for concrete to set up so that I can finish it, planned to finish filling up planter box with soil...

If you haven't yet dealt with the door hold open issue go see the folks who sell the pre-made garden sheds. They use factory made gizmos...

Probably better then gas in the bar oil...

I absolutely cringe watching the various home reno shows where the made for TV highlight is destroying perfectly good cabinets with a...

I needed some cabinets for my utility room and there are a lot of nice entertainment centers available for cheap, so... I picked up...

I coil them; plug the two ends together; and use these clips. I've never had any negative experiences doing this. There are several...

For everyone who responded here regarding glue/silicone: thank you. I've always wondered how undermount sinks were held in place and now...

I'm no structural engineer so feel free to tell me I'm an idiot. Could you eliminate every other post by using flat steel slabs, the...

I'm sorta jealous of these 3-D printed organizers. I don't do the 3-D printing thing but have friends who do. Are there files available...

I have a south facing outswing man-door on my shop. I've been here 25 years and it's been just fine for me. My shop is so crowded...

So you get to eat dinner at Lambert's every day... b-t-w; welcome to Missouri.