Recent content by Atlascycle

  1. A

    ZMotorsports Shop Projects 2.0

    It is strange that you have a mural of a step ladder on your drivers door Mike.:ROFLMAO: You keep that Black Jeep looking awesome! on the inside of the tail gate is that all of the trails you have taken? -Jason
  2. A

    Using a die to cut M4 threads on round stock

    Dude, you were getting very good advice from a Master Toolmaker, you were making the advice complicated, your drawing is showing what i assume is a 3D printed "Washer", Print a guide to keep the Threading die square and print a set of vee jaws for the Vice to hold the Aluminum Rod to keep it...
  3. A

    threaded reducer or bushing

    have you thought about using something like this? https://www.mcmaster.com/90248A031/
  4. A

    ZMotorsports Shop Projects 2.0

    Congrats Mike!
  5. A

    Thoughts on my garage

    1-1/4" over 9 feet is .6 degrees, only you know if it is worth the trouble
  6. A

    ZMotorsports Shop Projects 2.0

    Congrats Mike!!!
  7. A

    Between 485 & 705 SQ/FT 3rd time's a charm with a 3 car workshop

    if you have a ratcheting Crimper and the correct Dies for the Connectors you are using I would go that way.
  8. A

    ZMotorsports Shop Projects 2.0

    Mike, It is refreshing to hear you comments about your wife, I meet mine in the early Ninety's, we were both working at Walmart at the time. She has excellent tastes in everything, but her taste in men is questionable. I always joke that she is living proof that it is possible to get some...
  9. A

    ZMotorsports Shop Projects 2.0

    I have one of these I got from a previous job: It does not like cheap Zip ties even on the lowest setting. it works great for control panel work. Jason
  10. A

    ZMotorsports Shop Projects 2.0

    My day job has a similar setup to what SilverJimmy listed above, it works really well
  11. A

    Between 485 & 705 SQ/FT 3rd time's a charm with a 3 car workshop

    Logan, we had a little less out here, I have no sidewalks but a 25' x 75' drive to tend to, 47" snow blower for the garden tractor works wonders, it it was not in storage on top of a pallet rack, in an out building with no forklift access until after the snow gets cleared at work. 7P's got me...
  12. A

    ZMotorsports Shop Projects 2.0

    Mike, it is nice to hear I am not the only one that gets a lecture from my Wife about doing "Sketchy ****" and Being stubborn and not waiting for help, I bit me in the mouth a couple of months ago, was moving our generator from our shed to a built in on our deck, 9k Generator trying to push it...
  13. A

    Between 485 & 705 SQ/FT Factory 59

    So Sorry to hear about Benny, Jason
  14. A

    Show us your VFD conversions/installations

    Nice Tidy looking panel on that Drill Press. Jason
  15. A

    Between 485 & 705 SQ/FT 3rd time's a charm with a 3 car workshop

    Logan, what about 3d Printing "coasters" for the feet on the compressor to sit in to keep it from walking? Jason
See more
Top Bottom