Recent content by AZmike

My heaviest vehicle is about 2700 lb so the load rating isn't really an issue. I'm looking for something that would perform well in the garage most of the time, but wouldn't be too much of a pita to haul to autocross occasionally. I would be ok steel one, but speding more on a steel jack...

Has any one tried it out? It looks pretty well made for $99. Of course it’s from China. Some specs: 2-ton capacity Weighs about 50 lbs 4” to 20” iirc 1 year warranty Twin pistons Unladen lift to full height in 4-5 strokes I‘ve have bad luck with the jacks that I’ve bought at Sear’s and don’t...

I had the same problem. Even with the flower watering can my etch wasn't ccompletely even so more of the coating soaked into the some areas of the concrete. Another thin coat is necessary to get a uniform finish. If the first coat is already cured (24-48 hrs depending on the temperature iirc)...

When calculating cost you should probably account for two layers of rustoleum industrial epoxy. After the acid etch it takes a second coat to get a uniform finish.

After looking for the rustoleum industrial epoxy for quite some time I was surprised that one of the Home Depots in my area stocked it. It was $97 if I remember correctly.