b-boy's latest activity

Thank! I would have to dig around and see. Hoping I can get done with it this week as this 3 month project turned into a 6 month and...

No touch ups so far. This stuff is very tough. I did 2 coats, full flake coverage, and 2 coats of clear. My concrete was pretty new...

Look into rust bullet as well. I did mine about 7 years ago and I'm very happy with it. It's easier to apply than epoxy and requires...

Just picked these up....

Correction on the pin diameter...5/16"

Thanks. The 1/4" is what I was looking for.

Where did you get the locking pins? Do you have any more details on them?

I'm going to look into the locking pins. Seems like they should be on there already.

The dealer pointed to the bent rod as the most likely cause. They thought maybe a tree root or a piece of wood might have caused the...

That damage happened in about 15-20 seconds. That drive shaft was spinning fast and I'm assuming that the lifting bar was not the best...

Could be. I could never mow here without a welder, unfortunately. Seems like I'm sticking stuff back on that mowing deck all the time.

Spoke to the JD dealership. $1,250 for the repair. New drive shaft and lifting bracket plus they're going to sharpen my blades while...

I don't think there was any operator error here. I just mowed in tall grass. It wasn't even that tall. Seems like the setup is too...

So If the deck falls off due to a latch and the deck height is changed by the operator, it can cause a collision between the drive shaft...

Thanks for the video. I couldn't find that one. I'm still confused as to what might have happened. From what I could see, the latches...