b-dog's latest activity

I don't have any experience but these have been on my radar for a few years and I finally ordered a set of the 1x2 clamps. If you're...

A little table top from some Oak dunnage. Ammonia fumed with black wax finish. (Found a new product that I love) Time to dream up a...

Wow! Been so busy it’s been over two months since I’ve done an update here. Lots have happened so I’ll try to do stuff chronologically...

Here is the final results of my attempt to build a set of stairs into the back of this C.O.E. I'm planning to carpet the sides of the...

1/2" thick acrylic glued with M E K. cut the runners to fit the guide slots This one doesn't have the guides glued on yet. goes...

I have a few of the Snapons because they were on special one week, including this 30” beast: They’re a bit more versatile than pipe...

I wish I had one of those, instead I have back and knee pain.

Don’t laugh fellas - I’ve had this old space heater I nabbed out of the scrap for a little while now, as it had some handy looking...

Wrapped up a project that’s been on the back burner for a while. Garden bench for the Mrs. Made of 2x2 square tube and composite decking.

found some time for my C.O.E this week so decided to build the steps into the sleeper. got a good start before running out of material

@Callelle what are you currently doing for your locking extensions? @Jtels85 well I've got good news for you then! We've already been...

Cross post from the RV thread: The wife told me she wanted a rack to hang wet items to dry like swimsuits, towels, etc. I'd never...

I've been searching high & low, I'm disappointed that I can't find any pictures or videos of this one installed. The extra hole was for...

I made these hinges that accomplished something similar.

Sub'd to see the new sliding saw - living vicariously here. Do it!!