Recent content by B-Man84

Last Sunday the contacts in the pressure switch on my 5hp 60gal. Ingersoll compressor stuck closed and caused a heat issue that popped the head gasket and heated up the valve body pretty good. I ordered the replacement kit and installed it today.

OK. Good deal. My overhead doors would be 2 on one "gable end" and 1 on the opposite "gable end" in line with the door on the front left. I would guess that the bays would be fine @ 20' wide. I'm just sketching and thinking about a"clean room" in the back right with a flat storage area above it.

Thank you. I'm sorry it took me so long to get back to you. If you don't mind, I'd like to pick your brain throughout your build, as I'm extremely interested in this size and construction type. Do you have the bolt layout plans yet? I would like to know where the structural vertical supports...

Good morning, sir. I have a quick question regarding Buck Steel. I've been looking around to start planning a new shop, and happened upon Buck Steel. How did you come up with your slab/foundation? Did you buy the optional stamped engineered foundation plans? If so how did they come up with what...

Yeah, the roll is a little awkward. But they are definitely going in my tool box. The chrome is awesome and I really can't wait to try them out.

Look at what the UPS man brought me at 0930 this morning!!!!!![emoji13] [emoji13] SK86049 21 piece long pattern SAE. And my swag from HJE and SK. THANK YOU to Jori, Bull, and SK.

Awesome!! I don't think it mattered the size (that's NOT what she said...lol) , but you held up to your yes vote and participated in a special event.

Just got my shipping notice!!!! Projected delivery on the 10th!!!! The UPS man better get in gear and pick it up from HJE... [emoji13]

Order #29031. Almost $550 lighter, but what an awesome thing to be a part of. Thank you again Bull, Jori, everyone at HJE and SK for pulling this together!!!

First off I would just like to thank Bull, Jori, and the people over at SK that have worked so hard to pull this together. I'm in for a set of SAE long pattern wrenches SK86049. Hopefully there will still be a shirt left by the time I process my order. THANK YOU!!!

Ewils35, this is probably really late. Sorry for that, my notifications accidentally got turned off on my phone for when someone quoted me. It was pretty straight forward, only need a fan clutch tool as far as specialty tools. Hope if you already did do it, it went smooth, if not hope this...

Those are the greatest things since sliced bread for an electrician. I have never used one with interchangeable bits, but they beat the heck out of putting in plate screws with a standard screwdriver. On a trim out (where you put the devices in and hang the luminares), they get almost as much...

Replaced the water pump on my neighbors 97 Ford F350 7.3L Powerstroke.

My Snap-on guy used to warranty the Kershaw knives, but after Ken Onion left Kershaw, he has stopped. He said that Kershaw has changed their warranty policy and he can no longer do anything about them. I found that out after I turned one of my scallions into a flat tip screwdriver.

Thanks for all the welcomes. I'm glad to see I'm also among fellow Virginians.