Recent content by Badboybuggy

Hi all, Just a quick update.. There really is not much to a door, just enough to make putting it up without instructions miserable.. I found this .pdf that really helped out..http://www.odcroseburg.com/downloads/instructions_install_torsion_spring.pdf Short story long.. I did not have the...

Hello all, I was given a 16' x 8' insulated garage door with all the hardware.. but this is an old door. it only has 1 torsion spring. I was able to get the door to work manually up and down.. When I installed the opener that came with it the door would go up but could not push it down.. we...

I just built this shop it really took all the money I had. So work has plenty of pallets that they pay to have hauled away any chance I get I bring them home. Most if not all the lumber used on the cabinets is free. I took pallets apart to make the cabinets. I went to the Restore in town and...

Work has been throwing away pallets. So the frugal in me has been taking them home and reusing them. All of the wood in this bench and cabinet was reclaim wood. I also picked up a few " Russian birch" as my buddy calls it. It is 3/4 plywood type. Just shy of 4 foot square.

I just had a metal 30x50 barn put up.. the contractor used a 12" concrete saw to cut all the metal. There has to be a cleaner way to cut. Any ideas? Thanks.

This is Tom, I am from all over. I grew up in downriver Detriot MI. Started my testing career at Ford Motor Company running engine dyno's. Did some GM testing also. Went back to Ford, this time at Livonia Transmission. Then went to Autolite Sparkplugs for 12yrs. With the economy downturn and I...