Recent content by BARN ONE

You could pour a couple of concrete piers the same height that your floor will be and build off of them. Then later when you pour the floor pour right up to them.

Check out this home made vise I saw on craigslist. Someone must have been hard up for a vise! :lol: http://stlouis.craigslist.org/tls/3169803838.html

Do the bottom half then the top half! lol :shocking: Just joking, I agree end at a saw cut.

Bump Make an offer!!

Here is my lateral file cabnet. I like this one because the front is flush (no handles sticking out) I built a angle iron frame with casters for it to sit in. The drawers open full length, and interlock so only one can be opened at a time. I was even lucky enough to get a key to lock it. As...

Here are a couple more pics. I still have to snap a line on the roof metal and cut it off, they were just some scrap pieces I had laying around. The rafters are 2x4s laid flat. They are only spanning about 20" and I was trying to get all the height I could and still stay below the concrete...

The lateral file cabnets are your cheapest bet. I took one and built a angle iron frame with casters for it to sit on, it works great. By the time you buy peg board and material, you could probably get a cheap used box.

And union cards! ^^^^^^^ lol Looks like its coming along good. Keep the pics. coming! :thumbup:

Here are some pics. of a small lean to tool shed I built at my lake place, down on the lower side of my 10x10 storage shed. I made use of some other wise unusable space, there were 2 concrete retaning walls allready there so I only had to build 2 walls. The BEST part is it did not cost...

I bought a outdoor one at Lowes on clearance fairly cheap. Its about 12-14 inches dia. I put it outside and when the sun hits it the needle almost pegs! If its in the shade its pretty accurate. What can you expect from a cheap piece of junk.

MAC open end wrench 3/4" on one end and 11/16" on other end. Number DR2224 good used condition $12.00

Thanks. I had a chance to get one last year for free at work. It was taken out of a confrence room, and only a couple years old. The problem was it weighed about 600lbs. I think it had glass panels inside the material for sound proofing, and it was to tall. I did not see any good way to cut it...

Your right they should be, but I know its been tryed with the tool boxes and its a NO GO. Says right on the back of the coupon excluding tool storage.

It probably would have worked better if you would not have been working on it in that old messy garage! :lol_hitti VERY NICE!! :D

Where did you purchase the dividers? How expensive are they?