Recent content by be0tch

Great. Found it. Thanks guys.

I'd like to get the Koken extensions but I haven't seen them for sale in 1/2". Maybe I'm doing a bad job searching. Where did you get them?

Did someone say Tone RH4CHS? Here's a mini speed ratchet I have for wheel lugs. 1/2" drive in a mini 3/8" body. Tone RH4CHS, KTC extension, Koken nut-grip 19mm.

My M18 1/2" mid torque takes off 100ft-lb lugs effortlessly. Yours is not operating normally if it can't take off a 110 ft/-lb lug.

I had a good experience ordering gearwrench socket sets from them. I'd buy something from them again.

Good idea. Cleaner than gluing in cardboard which was my initial inkling.

Mine arrived today. I feel that it was a good deal in spite of the fact that the 3/8" set was scattered around inside the blow mold and the case really does not hold the pieces at all. I am either going to have to modify the case or put these pieces in a better storage solution. Walking while...

I have the HF #69420 (lol) screwdriver set. I would categorize it as useful for when you want expendable screwdrivers to lose somewhere. This model is low quality and bends easily. It does seem to fit fasteners just fine though, and the inclusion of t20 torx is nice.

I see more Makitas than anything in BK. Maybe a few pieces of yellow or red but its mostly Makita.

The rebuild kit arrived. The banana rides again! Comparing the new pawls to the old pawls, it was clear that the old ones had seen better days. Replaced everything and added oil, now its smooth as ever.

I took my snap-on banana apart using the help in this thread and I can see now why it is slipping in reverse: the pawl on that side is broken. I am going to give rebuilding it a shot when the kit gets here.