Recent content by Beaks

Ok, so diamond grind over the peeling areas, and patch over with the same epoxy? I can do that.

Hello- Last summer I used Rustoleum Epoxy Shield to coat my garage floor. I thought I was very through in cleaning, etching, and drying the garage floor before applying the epoxy. Two coats were applied and the results looked great. This winter was harsh, and there was a lot of dirt, salt...

So I applied the Henry Patch n'Leveler about 15 hours ago. On the thicker patch spots it is still a little soft if you press on it. Do I have to wait for it to be completely hard to paint over it, or if I carefully paint over it while soft, will it continue to cure under the paint?

Thanks again for the replies, I etched my floor this morning and will be filling in the broken concrete tomorrow. A couple more questions. 1) Do I need to use patch very small holes or rough spots of concrete, or is the epoxy thick enough to just fill that in? 2) I was planning on using 2...

Thanks for the reply. Do I need to lay the floor stone before etching?

Hi Everyone- I'm a new homeowner after having rented for 12 years. I'm getting ready to prep my garage floor for Epoxy covering, but I had a couple questions I was hoping you could help me with. I hope these questions aren't too basic, but after renting for 12 years, I don't know much about...