Recent content by Bedrok

Juday, thats a good looking shop! Did you finish it in galvanized roofing or aluminum siding? Does it support the weight of insulation? Thanks, Bedrock

I'm getting ready to wire my shop for lights and I have decided to use the Lithonia T-8 lights (tc 232 -1/4 geb 10) and they have 4 4' bulbs each. This is a hobby shop for car repair. I'm looking for some recomendations on how many to install. My shop is 32' deep and 42' wide with 12' 4"...

I'm getting ready to install a 6" round chimney through my metal roof. Does anyone have any info on how to flash a metal chimney going throua metal roof? Thanks, Bedrock

thanks everyone for your input!

Anyone have any good plans for burning used motor oil in their firplace. I plan on making some kind of drip system for mine. Thanks, bedrok

I'm getting ready to install a shop sink. Anyone have cool photos of theirs? Thanks, bedrok

I would be using them on 12' x 11' insulated doors. Thanks, bedrok

Does anyone recomend jackshaft mounted garage door openers? If so what brand and models? Thanks, bedrock!

I have decided to install T8 lights in my 42 x 32 shop and I'm looking for advice on the quantity, brand, and recomends on two four footers per fixture or four four footers per fixture. Thanks Bedrok

I'm getting ready to install lights in my 42 x 32 x 12' 4.5" shop and I like the CFL lights but the high watt bulbs are large and hang down low. I'm installing a Bendpak 2 post lift and when I raise a vehicle on it I don't want to worry about hitting the lights with a car. Would you guys...

I'm starting to run the electrical for my shop and I'm installing 12 300 watt CFL bulbs. Does anyone know of some good fixtures that go above the bulb to help reflect light? I'm also looking for a recomend on yard lights that have a photo cell and come on automaticaly. Thanks in advance

There is a special tip you put on your Paslod staple gune and it holds the staple out so the siding can move a little.

Yes the siding is stapled on.

I have sided my walls almost to the top and I need to put the top piece of siding in the upper J channel. I know they make a punch to hol your last piece in the J channel as long as your cut is on the low side of the siding. Is there any other way of doing it? Maybe silicone the last one or...

second try