Recent content by beedle

its really nothing special. just some chezzy pliers with a derlin rod on it. I've crimped them with a socket/pliers w/out issues if using common sense.

New snap on flex is out...

love my snap on, but this is a good deal from a good brand. https://www.jerseydiscounttoolco.com/product-page/vim-3-8-drive-hand-impact-driver-and-bit-set

https://sugru.com/

Awsome thanks

oxford, and lapeer normal too

I have 3 meijer local. one had a huge whole isle all size wrench separately etc. Then they did a major slim down to some basic sets only. I dont get it?

Just picked up a used krsc246. Have a ringbrothers special Ed dragon mustang krl1022

Picked up a used KRSC246. (Same as current KRSC242 but stripped down. No speed drawer, no accessories panel, no power) Added the large HF folding shelf. And a can rack. It's a beast of a cart.

Most are mad by sunex, so check there. Hinge is welded on I believe? So just get a piano hinge and burn it on

How well does this work? Never attempted to to one w/out removing the knuckle

Any tire shop should have the snap in tpms stems in stock. Cost about 2-5 bucks depending on where you go. Is said jeep a JK? swapping the wheels?

We use those, the soft roloc pads, and a needle scaler if needed to clean hubs daily at work. They work well.

Coworker is getting a 40" green one. And its only 500! He said the same thing felt alot stronger than any of the c-man chit.

Looks like the HF one, I love mine.