Recent content by benzor

I have a saga to share on my MaxJax. I bought a new set of anchor bolts, and am on my third warranty call to them for incomplete package shipped. First time I only got two anchor bolts, loose (not in the box) Second time I got ten anchor bolts, but no sacrificial setting bolt. Third time I...

The loading and unloading I have not figured out, regardless of whether it is in X3 or Uhaul (without a lift gate). I may not be able to get the lift as a result, because I can't see how my wife and I could get it into and out of a truck.

Wow, that’s more than the 400 pounds per post I was guessing.

I'm looking at moving a Triumph C7000 in my X3 about 60 miles, one post at a time. Any guesses as to the weight of one of the posts? I see MaxJax lists 880pounds as their total system weight. These are a little taller on the Triumph. National doesn't quote a shipped weight. Any guesses?

Good pointer, thanks! Now I'm trying to figure out what the individual posts on a Triump C7000 weigh. Want to see if I can take them home one at a time in my X3....

Good point. I expect controls and electrical also needed, maybe that makes it easier to buy them as a package?

I'm looking at a great deal on a Triumph C7000 Lift, missing the pump. Wondering if anyone knows if they sell the pump separately? Thanks!

Thanks for all the suggestions!

Thanks for the suggestions! If I'm filling the cavities, vapor barrier would be interior of insulation, correct?

I have a very short peak (2ft long) on an almost square garage. I'm intending to insulate between the rafters (7in deep available, intend to have air gap) to keep the interior cathedral look, and understand that I should have airflow from soffit vents through to the peak Interior size is...

This is city water

That's a good "idiot test" (ha!). I suspect it won't work, but will try !

Unfortunately not - outside diameter (OD) is 0.773in. I checked a couple of locations

Thanks for all the replies! I'm very appreciative. I'll try to answer questions : - I am converting the inbound system to PEX, but need to mate to brass when it transits through foundation. I don't want the headache of drilling a new hole in foundation. - 1/2 copper doesn't fit into ID, but...

Hi Everyone! It is a great time to be doing projects. I'm trying to run a new water line, so I can wash the cars outside of the garage. We have an existing brass pipe, but it is full of pinholes. I need to reuse the location where the pipe goes through the foundation, so I'm trying to mate...