Recent content by bethomas

Thanks Everyone. Correct, they are linkable end to end with a cord. There is no plug cord. My options were drill a hole in the end of it or attach jbox to ceiling and lights to j box. thanks again

Installing lights in my garage with surface mounted conduit. About 75% of my ceiling is not accessible from the attic, so i'm using surface mounted conduit with LED lights mounted flush to the ceiling. The lights i'm looking at (linked below) are Smart Electrician® 4000 lumens 48 x 5 LED Wrap...

Thanks! I'll give that a shot. I think I see where I went wrong, but I just copied the wiring from the Watson diy page. Could it be because I'm only using one side of a double pole switch? I don't think it should matter though. Same goes for pulling the power either from L1 or further...

Thanks. It is attached to the post above yours.

Greg, see below. The others that i quoted in the OP put the switch in between the leg from the L1 to the thermostat. Thanks, Brandon

Thanks Greg. It is 240V, so there isn't a neutral line. I used the same wire i used for L1 and L2 since I ran EMT.

Good morning all, I have my Fahrenheat FUH54 wired up according to the following posts that I found: Coloradotrail rider: http://www.garagejournal.com/forum/showpost.php?p=2517843&postcount=48 in the thread Installation of Dayton G73 Heater with Cutoff Switch and Thermostat" bottomfeeder's...