Recent content by bgood1130

  1. B

    craftsman block grinder for parts

    price dropped
  2. B

    craftsman block grinder for parts

    I have a 7 inch block grinder, 397.19590 for parts. One of the wires is broken right where it goes into the motor windings. It is disassembled, but I have all of the parts. not looking to part it out $40, buyer pays actual shipping. item in green lane, pa, 18054
  3. B

    What did you do "IN" your garage today?

    Yesterday I did some repairs on my kalamazoo 816 saw, and some cleanup.
  4. B

    Kalamazoo 816 Bandsaw

    I have an 816 that has been around my shop for a while, and I am just getting around to trying to get it operational. I have already made a couple of repairs. One of the eccentric screws for the horizontal adjustment was stripped due to someone using a nyloc nut on it and making it too tight. I...
  5. B

    let's see your craftsman block grinders

    If you notice the wire that only has a couple of strands left, that is immediately where it goes into the stator. That wire did break off during disassembly. Attached is a picture from a different angle. You can just barely see a tiny bit of wire sticking out of the stator to the left of the...
  6. B

    let's see your craftsman block grinders

    Here are some pics of my 2 block grinders. The first one I got for $10 from a buddy who picked it up for that price at a yard sale, before realizing that he already had enough bench grinders. The second is currently in pieces. It came from a storage space at work that we were clearing out to...
  7. B

    looking for block grinder parts

    So the armature is 2.620 in diameter, from outside to outside of the bearings is 7.790, and the OAL of the shaft is 16 1/4 (roughly with a tape)
  8. B

    looking for block grinder parts

    Here are some pics of the grinder (in pieces.) I didn't take any before I disassembled it. As can be seen, it is in great condition short of the wiring problems. I would hate to not be able to save it. It was given to me at work, as it had been in storage for a long time and we needed to make...
  9. B

    looking for block grinder parts

    Thanks, I will get some measurements for you. Could you also give me the model number? I can't see it in the pictures you attached.
  10. B

    looking for block grinder parts

    here is a pic of the stator. You can see where the wire coming out of the stator only has a couple of strands left. Needless to say those strands broke as I continued to disassemble. I don't know how this could be repaired since it is right where it goes inside of the stator.
  11. B

    looking for block grinder parts

    Hello all, I was given a 1/2 hp 7" grinder a little while back. I had been using it without problem, until one day i turned it on and it arced. I took it apart and found that much of the insulation was missing from the stator wires. One of the wires only had 2 or 3 strands of wire left holding...
Top Bottom