Recent content by BigTicket

240 dragon tooth washers. Heck of a deal if you know an electrician. These retail for way over $2 a piece. $200 includes shipping in the CONUS.

Mr. Cool and it works great both cooling and heating. I had a 7500W Dyna-Glo heater that I decided to mount on the opposite side of the garage from the Mr. Cool to help with heating.

I was looking at the HD model. You're right.

It's about a thousand dollars difference for the 9K with Wildfire being cheaper. Not sure about deals or shipping.

I can recommend the Wildfire 4 post. I've been pleased with it. It's a carbon copy of the Advantage Lift. Regarding the rolling bridge jacks, I bought one from Wildfire and like it. They are reasonably priced compared to some others, but KaTool makes one that I just bought to have two. I am...

KaTool KT-830 I purchased this KT-830 a couple of months ago. I am very impressed with the quality. I had no problem changing wide, low-profile tires with the double-assist arms. It takes some practice to get good at it, though. I bought this from a guy who had it in his home shop but was...

Update. I switched back to the 50-amp GFCI breaker, and as before, no tripping. I will pick up another 40-amp GFCI and try it again. I think it was an issue with the 40A GFCI breaker. Wiring looked good, and using the same receptacle with the 50-amp breaker without issue.

Correct

It is a single circuit. I either plug the welder in or I plug the heater in. It's either or. I'm think the receptacle has an issue. Will test as soon as I can. Breaker is off until I figure it out.

I suppose the mention of the heater was a little background info. It's the reason I swapped with the 50A breaker which never gave an issue.

No. Just a 6-50. Thanks.

I'll do that. Thanks.

6Ga wire

GFCI. It will trip with nothing plugged in.

I have a 50 amp DP Eaton GFCI that has been in use for almost a year and a half. I have been using my welder on it. I recently mounted a 220V garage heater and it uses 31.25 amps. I swapped out the 50A breaker with a 40A Eaton BR GFCI because that is sufficient for my welder and will accommodate...