Recent content by bigwater

The 1' was today without a car. I want to verify all is good before I keep loading the car. I guess I need to test it with the car loaded again. I will try stopping it as soon as it hits the lock and see if there is a difference.

The lift is 4 years old. It was sitting in a friend's shop and I just started using it. It takes about 8-10 seconds to start going up. I hold the down button until fully locked and couple seconds after. Too long? It does seem like it is rebuilding pressure. How do I test the lowering valve...

I have a Challenger scissor lift similar to the Bendpak. When I lift the car from the ground, it goes up right away. I find the height I want and lower the lift for the safety latch. Then when I'm finished working on the car and it has been in the air for a while, it takes a lot more time to...