Recent content by Bill Anderson

K5 hands down!

I've had the K3, K4, and currently K5. The K5 master system is well thought out, and have features the other two lack. The K4 is, imo, a poor design by Kreg, possibly a cost cutting move. The handle layout is not convenient to use, among other disadvantages, compared to the K3 and K5. I like...

This, call to check if you S-W has it in stock. Water based poly, durable and water resistant. Perfect for your application...

Hilarious...keep looking out for him.

If you can't get to the back side, it will still be a solid repair, just being repaired from the front. Repairing from the backside, as well as the front, is just extra insurance. Just slightly 'V' out the cracked area, and make sure to wipe thoroughly with the adhesion promoter pads.

Here is an application gun and tubes you can use to apply the adhesive, if you choose. http://www.amazon.com/dp/B002QWYG1O/?tag=atomicindus08-20 Mixing tubes http://www.amazon.com/dp/B00596QVHG/?tag=atomicindus08-20

This http://www.amazon.com/dp/B002INUIVS/?tag=atomicindus08-20 This http://www.amazon.com/dp/B002NETGBA/?tag=atomicindus08-20 This http://www.amazon.com/dp/B002NEV7I0/?tag=atomicindus08-20 And this http://www.amazon.com/dp/B00HSCMGBY/?tag=atomicindus08-20 Cut a section of the plastic mesh...

Yes! :evil::FIREdevil. Repent now! Lol

Really?!

@Mronetwo, the Miller 211 dual voltage that 90zcar mentioned is one smooth machine, probably one of the best, smoothest welding migs i have ever used. If u can get something like that, it would be the last machine you would ever buy for home/diy use. It also has a spool gun plug in on the...

@Peter, I prefer the Dewalt over the Festool, for 3 reasons. 1. The Dewalt track's guide (the part the saw rests/slides on) is centered on the track, so you don't have to flip the trach end for end, to make different cuts. So both sides of the dw track has rubber edge (lacking the correct...

Hey Chowderhead, I misspoke, I don't have the Sam's Club Michelin dual purpose jack. I have the Michelin 2.5t aluminum/steel jack that they are currently stocking. When I was referring to hybrid, I meant the steel/aluminum combination. I couldn't get the sam's club link to work, so I assumed...

Very considerate of you to look out for him Wizard. You sound like a good FIL.

That amazon link is exactly the 3 ton i have. Actually they are nearly identical, other than the lift capacity. The 3 ton may be a little bigger, as well as a little heavier, but lift height is the same. Both are good jacks. I got the one from Sam's because it is lighter, and easier to...

CPO Milwaukee, currently has a special, if you but the 3/8 impact, they'll give you the 3/8 bare tool ratchet for free, for $199. And any order $199 and over ships free.