Recent content by Bill_993

Makita 7 in. with the Diamabrush shroud. The Makita shroud doesn't work - interferes with the Diamabrush disc. My garage is only 18.5 x 18.5 feet, didn't take that long to grind with hand grinder.

Closing out this post with my outcome. I ended up using all Ghostshield products - Started with Eco-Etch 1001. I wouldn't say it was necessary, but it did seem to make the concrete more consistent in color. I vacuumed the floor before using, but the process of hosing the Eco-Etch off with...

I have a Parker 974, also purchased at garage sale, didn't have to do anything to it, works great.

Shea, one final question. My other option is to apply SPGX Polyurea over the bare floor (I don't have any interest in flake or solid coating). I found this option attractive since has unlimited pot life (easy to apply). I did get a VaporTest result from single location of 2.81. I expect...

Shea, thanks for the reply. Water doesn't absorb right away, takes a few minutes. My concern was that the there isn't enough pores for the sealer, but you think otherwise. My order of the 8510 will arrive by end of the week. My plan at this point is to test the 8510 in a 12" x 12" section...

Hi, I have a 20year+ concrete garage floor and want to re-seal using Ghostshield 8510 sealer. I'm open to other suggestions or products - note garage is bottom level of house so don't want any high VOC solution. I did perform a single Vaporscore calcium chloride test with results of 2.81. I...

I'm seeking advice for re-coating my 30-year old garage floor. - I power washed it today and it definitely has an existing sealer on the floor - beads water well. But looks ugly since has paint, rust, tire, and oil stains. Power washing didn't do much to remove the stains and didn't remove...

Thanks Mr. Vines. The seller on Craigslist, believed it maybe a Chas. Parker. Here is the full seller's description. "I have completely restored this vise. It was given a chemical bath and taken down to the bare metal. There is absolutely zero damage or repairs anywhere on this vise. It has a...

Is this (image attached) a Chas. Parker No. 7 vise? Found listed on Craigslist for $80. Thanks in advance for any help or insight.