BillK's latest activity

Sorry. I do SAE. And I bet 99% of people on here do the same. But for what its worth the press fit should be in the area of .050mm...

One more probably stupid question but i have been fooled by it myself. Are you sure the press has not reached the end of its travel ...

Woah !!!!!!!! That is a .060" difference ???????? Something is not right. Probably the new "sleeve" It should probably not be more...

A typical thread where people come and ask for help, they are offered good options, yet they continue to not heed the given advise...

Sometimes people are better off writing a check and having a pro come do the job. . . .

What is the most air you will use at one shot ? I just looked at the specs on my Van Norman blast cabinet and it uses 16CFM. Unless...

Bottom roller at about 30 seconds Click on the "watch on You Tube" link

Just curious why you needed the e-mail ? Why not just go ahead and buy it while you had her on the phone ?

There are several ways to do it. If you simply "google" "replace bottom garage door roller" you will see the options. You put the...

There are quite a few available for model aircraft use. Do a search on RC Model Aircraft Tachometer...

This ↑↑↑↑↑

As has been suggested a handful of times already you need to relieve the water pressure around the building if you think it’s coming up...

It sounds to me like it almost has to be the contactor stuck closed. If the inside blower shuts off the thermostat is doing its job.

Personally I am not a big fan of the large corners at all. But I also dont know the overall site plan etc. Are there other buildings...

But it is almost certainly finding its way under the slab. Fix the drainage so it no longer puddles and I bet your wet spot will be gone.