Recent content by bjtstarfire

Google high lift garage tracks. New jack shaft openers.

Check this out http://www.toolking.com/durahook-901-peg-board-hook-assortment-kit-26-piece

Craftsman had a branded product that I have called "power pegs" and they worked great and locked very well. I have not seen them lately and now I use Wire Ties as suggested above.

Thanks All. The wood handles are older file handles my dad had that we reused vs. the original ones that were all cracked. The wood handles were very much the same but smaller in length. The table was not drilled or abused to much, so I didn't need to fill it. It did have a lot of rust that...

I just finished putting this back in service.

I have the same issue with my sears locations and constantly tell them they are driving us away. They don't seem to care that they are selling out and the worst of it is that they will want to replace my USA tools will non USA tools. At that point I will demand the value in cash and buy some...

You learn something new every day. I thought this was the same co. "PLUMB" my father worked for in Phila. Pa. which made hammers.

It is PLUMB.

Use a product called STIX and you should be fine. http://www.insl-x.com/viewCat.asp?catID=53 Ben

Good info on the reply. I though it seemed a bit silly to do it one handed. I also prefer to push the belt sideways with one hand, and turn the pulley with the other. I think my belt is set well without undue loads on the steps as well as rotational parts.

New to this site, now I am on HAMB and here. I love the information that is shared at both.

Tool background: 1949 Buffalo # 15 Drill Press 5 Speed. Question: How does one do the following (The DP documentation states “When the motor bracket is set properly, the belt can be quickly run over from one pair of steps to the next, simply using one hand and without changing the motors...