Recent content by BlackKnight2538

Update:12 hours later it held. Didn't move a millimeter! Thanks Again to all. Merry Christmas also

Hi FIVE to Hiball for your help. Got the new piston seal u-cup and cleaned everything real good. Assembled the jack, went through bleed procedures. Appears to work great. Put a real load on it today and will see if it holds or leaks. But so far so good! Thanks Again!! :beer:

Ok Hiball thanks for your help. I'll post updates when I rebuild it.

Hiball well I got the end off cylinder and heres what I found. 1) loose screen. Im guessing it lived in large bottom hole. Probably not use huh. 2) Got excited when I saw this crack in seal. I'm thinking that's not supposed to be there? 3) Got sad when I saw these 2 grooves/cracks in cylinder...

I was afraid you were going to say that. Boo. Everyone post what a pain getting them open is. Any advice on how to best do that? Thanks Much

Not sure if you have seen this before. But a nice frame by frame of the basics stages of operation of a jack. http://www.hyjacks.net/ani_extraction.htm

MVP Jack with foot pedal - Needs help Wow great forum for these old floor jacks. Thank you all. I have a MVP Superlift jack. No idea of actual model or weight capacity. The basic physical assembly best resembles Binovc's MVP jack due to the foot pedal option (#210 post). However the bottle...