Recent content by BlueDodgeRam

Here is mine. 30x50. No build thread yet though, even though it's "done" for right now.

I have a 10x10 roll up door on each end of my 30x50 shop. The doors are made by DBCI I believe. They currently only have latches that operate from the outside (think storage unit) and its getting annoying having to walk around the building to open up the one door. I'm sure I'm not the only one...

XPR-10 to 24149? Thanks!

Definitely going to keep it wet for the first day or two. I use a picture of my first dodge rockcrawler on another forum im on so maybe. I have not heard of those lifts. I will check it out. Have looked at Mohawk, Rotary, and Bendpak. Mohawks are nice and beefy but expensive and probably more...

Thanks!

I'm just using AutoCAD (I'm a mechanical engineer so I use it daily at work). I guess the "rocket" you're referring two is the Bendpak XPR-10 2 post lift I'm planning on installing. I have everything drawn in layers. Red is for all "tool/equipment". Thanks! Planning on pouring a floor, 5"...

Hello All! I'm in the planning stages of turning an existing 30'x50' metal building that was used as a barn into a full workshop. Been reading alot the past few weeks and have gained lots of knowledge already! Look forward to getting the shop completed! I have most of the floorplan laid out...