Recent content by bob206

Gentleman, Used a m12x1.25 plug tap and slowly turned the threading, backing out every other turn. Used some CLP oil I had laying around. Clean up the threads nicely. Thanks guys!

Thanks for this insight. I'm having trouble picturing the stud instead of the bolt. Can you give me an example? Thank you!

Great information fellas! Glad I found this site. So far I purchased the following. -tapered plug m12x1.25 tap -m12x1.25 thread chaser -heli coil m12x1.25 kit + 31/64 drill bit I'm going to try to the thread chaser first then the tap. If I royally screw up all the threads I will use the...

I found these off amazon.com. Would these work as a chaser? https://www.amazon.com/dp/B01JMRZCV8/?tag=atomicindus08-20

It is fully boxed and unable to get to the back.

I stripped some threads off a hole on my trucks frame. This is 1 of 2 bolt holes used to help secure a steel winch bumper onto the frame. It is M12x1.25, the right side screws in fine but I accidentally threaded at an angle stripping and mangling up the threads on one hole. Now I can't get the...