Recent content by BobH

If you upgrade to a larger capacity battery can you still charge from the built in usb charge port?

Here's another Reed 205 1/2 to add to the list. Last patent date is Aug, 1914 and the date stamp is 2/15. 105 years old and just put back to work. Bob.

Wall mount shop vac sighting! The HD on Saw Mill River Rd in Elmsford NY had 10 or more on the top shelf over the vacuum display. Go get 'em.:)

Apparently they're both out of production so off to ebay I go. what's the difference between them? I'm looking for the smallest one. Thanks Bob

I have a Snap on ratchet thats 3/8" drive in a 1/4" body and it's great for under the dash work on equiptmemnt. Do they or did they ever make one like that with a 1/2" drive in a 3/8" body? If they did a part # would help the search. Thanks, Bob

Wright for me.

The search won't search back to older than Dec 06 no matter what you select for me

The saw cut control joints are mostly for contraction so dosn't it stress the pex if a joint opens a little? What do you do where you have a full on expantion joint in a large slab? Dip down into the sub-base and back up again?

Just what I was looking at. :thumbup: Are installation instructions available on line? It has to be more complicated than dig a hole and pour the plastic liner in concrete. They seem to cost about twice what an equal above ground would be, but not having posts in the way, priceless. Does any...

I'm in the planning stages for a new house and shop. I was looking at a Rotary 10k in ground lift. They seem to have fallen from favor and was wondering if there is any reason besides the difficulty to install. Bob