Recent content by Bohdan

  1. B

    Between 485 & 705 SQ/FT Mid-Century Moto Mecca Makeover

    Put a gouge tip on the plasma and blow the welds away.
  2. B

    Between 485 & 705 SQ/FT Mid-Century Moto Mecca Makeover

    Try switching the two wires that go to L1 and L2.
  3. B

    Between 485 & 705 SQ/FT Mid-Century Moto Mecca Makeover

    Just a comment on your battery mount. I have a similar exposed mount in a tractor and find that when a thick layer of dirt collects on top of the battery and it gets wet it slowly discharges the battery. You need a cover over the battery to prevent this. Hurry up with the videos. :thumbup:
  4. B

    Between 485 & 705 SQ/FT Mid-Century Moto Mecca Makeover

    Not sure if this will solve your shimmy problem but here it is for what its worth. Some time ago I had a Range Rover that developed a real bad shimmy every time it hit a bump or pothole and I managed to solve it. It was caused by having an incorrect toe out (4 wheel drives have a toe out not...
  5. B

    Tooling (Re)Organization

  6. B

    Tooling (Re)Organization

    Pics are there under IE10 but still missing with Firefox 60.0.2
  7. B

    Between 485 & 705 SQ/FT Mid-Century Moto Mecca Makeover

    If you switch it off and leave it for a while sitting level it might come good.
  8. B

    Paid for USA, got China

    Origin is where the seller shipped it from, not where it was made.
  9. B

    Cutting Unistrut Straight

    But Festool actually sell a blade specifically for that. :dunno:
  10. B

    Can you name this tool

    You beat me to it.
  11. B

    Wire Resistant to Metal Fatigue

    Copper strain hardens as you bend it so it will break in time. It just might last longer than most commonly available wires.
  12. B

    droped my router bit.. should i be worried at all?

    It would be unusual if the steel was hardened as the cutter gets all of the hardness it needs from the tungsten carbide teeth.
  13. B

    droped my router bit.. should i be worried at all?

    If the teeth are OK then it is probable that the cutter is fine as it is unlikely that you would have bent anything. The teeth are very brittle and can be damaged very easily but the damage is very obvious.
  14. B

    small allen bolt removal

    The last screw that rounded the hex drive hole I used a nail about the same diameter as the drive hole, put it in a drill and ran the nail in the screw at high speed. The resultant friction heated the screw to red heat without damaging the surrounding surface and the screw released with just a...
  15. B

    How do you run multiple speakers?

    You can hook up 4 identical impedance speakers to an amp circuit by connecting two sets of two in parallel and then the two sets in series. The resultant load on the amp is the same and each speaker plays at 1/4 power. The only problem is that you can't do any switching and the wiring gets more...
See more
Top Bottom