Recent content by brachus12

Loosen the two bots holding the motor plate to the back of the press which should allow the motor to slide closer to the spindle pulley and put slack in the belt. If your motor plate is already right against the head, your belt may be too short. Sent from my iPad using Tapatalk HD

Anyone find a source for replacement air hose reel swivels? I have an OLD Coxwells Inc air reel I'm rebuilding. (Yes - it predates the name change to Coxreels) I think the swivel is too far gone to just replace O-rings (IF I could even find the correct ones) Lots of rust in the hollow bolt and...

Grace USA has some good reviews on their hollow ground screwdrivers from the firearms groups. Was considering a set of my own.

Anyone have more info about Coxwells air reels? Is this the same company as Coxreels? Picked one up this past weekend in good shape. Needs a repaint, new hose and prolly o-rings. Sent from my iPad using Tapatalk HD

I just found J-7583 (minus the center screw) which some other Jeep manuals say could be used in place of J-9233.

Continuing to install ceiling insulation

Forgot to mention that... It's 12/2

I'm preparing to wire in the switches for my overhead lights. I have a deep plastic 3 gang box for this task. I want to mount three switches, each running off to a separate string of lights, but incoming is only a single power source. Do I need to use the pigtail method for the hot wires? I...

Don't keep us in suspense! What was decided upon? I have a similar situation and am leaning towards a densifier/sealer.

Any updates? How did it urn out? Sent from my iPad using Tapatalk HD

I have a similar question about ballasts labeled like this. Isnt 277V three phase power? So by the label, 120V if you have single, and 277V if three phase? Would you still be able to use 240V single phase on these? Brachus

I want to have a 120v outlet below the 240v outlet for when I use the smaller Lincoln 100. Any code issues from that? Can I run both wires (6/2,12/2) through the same 3/4 hole at the top of the wall? Sent from my iPad using Tapatalk HD

What about buildings in Southern climates? For most of the year the outside of the building is the warm side of the wall.

I may go with a single receptacle then. Run to first outlet is about 25' from panel. Is conduit required for this even though it is mounted in the wall and ceiling?

Did you pigtail off the first receptacle or split from a box before the receptacles?