Recent content by bradleyheathhays

Just finishing up this Bondorific patch job on my rocker panel (and opposite side rear panel section) and need advice on how to finish things up. I believe I've read that bondo can be spread as thin as you want as long as it has good mechanical adhesion, but I'm wondering as I do these...

**** didn't even know there was a thing as slip rockers! Ugg yeah that would've been much easier and better looking. At least I know how to 'replace' it properly in a year when this all goes to ****. Well here's where I am now. There's bent 1/8" diamond plate aluminum riveted in for support...

So I've got a decent looking survivor jeep and the only obvious body problem it has is the driver side rocker panel. The panel itself is rusted through and although the overall plan is to completely replace it, for now I just need to fill in the hole and keep it from being what draws your eye...