Recent content by bray101

I did think of the powered vent route, along with any surface mount vent type. I just wasn’t sure how to do in insulation of the ceiling. Meaning: should I foam board on the bottom of the rafters leaving the 6” gap for soffit vent to vent towards the powered vent? The louver vent I currently...

Hey all...Finally getting around to finishing the interior of my new building that was constructed over the last winter and am running into a question I don’t know the answer to, nor can I find a situation just like mine in any forum or website that I see as possible. Decided to have a 4 x 8...

Any idea on what to use outside of a spray application? I didn’t think of the 1.5” foam, and it may prove quite difficult/impossible to slide those behind the framing at this point without snapping the foam in half...

Thank you! If I just use batts that go up to the horizontal purlins and create an additional air gap, would that be a problem? Or am I taken care of due to the vinyl/tyvek/plywood sheathing combo already? Thanks.

Hey all. Been reading the site for awhile, but this is my first post. I’ve searched and searched...and then read and read some more, but I can’t seem to find someone with the exact question I seem to be obsessing over. Recently had a 32x40 pole building constructed. Storage space in the...